6
Uplink connections:
Like any switch, any compatible switch, hub or other network
interconnection device can be attached to the Uplink (MDI) port
on the switch.
1.
You may connect from an MDI Uplink port on the switch to
any of RJ45 MDI-X port on the target device.
2.
Prepare straight-through shielded or unshielded twisted-pair
cables with RJ-45 plugs at both ends. Use
100ohmCategory 3,4 or 5 cable for standard 10Mbps
Ethernet connections, or 100ohm Category 5 cable for
100Mbps Fast Ethernet connections. When inserting an
RJ-45plug, be sure the tab on the plug clicks into position to
ensure that it is properly seated.
Note: When the MDI (Uplink) port is used, the latest port
(5
th
/8
th
/16
th
port on the 5/8/16 ports switch) cannot be used.
Both of the two ports are not allowed to operate at same
Time.
7
FCC Warning
This device has been tested and found to comply with
Limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the user’s guide, may cause interference
in which case user will be required to correct the
interference at his own expanse. However, there is no
guarantee that interference will not occur in a particular
installation.
CE Mark Warning
This is a Class A product. In a domestic environment, this
product may cause radio interference, in which case
the user may be required to take adequate measures.
