GN-GT8S Gigabit Ethernet Smart Switch
5
Chapter2 The Gigabit Switch Configuration
Local Console Management
You can manage the Switch locally using HyperTerminal; simply connect the Switch to a
PC or workstation through the serial port.
The serial port settings need to be configured before connecting to the Switch. In order to
change the settings of your port, run the
HyperTerminal
program. This program comes
packaged with Windows, but it may not be installed on your computer. It should be located
as is shown below (varies according to operating system). If it is not, consult your Win-
dows documentation for instructions on installing HyperTerminal.
To enable communications with the Switch, the serial cable must be connected between
the Switch and the computer.
Make sure both the Switch and the computer are powered down. Next, plug one end of the
serial cable into the console port of the GN-GT8S and the other end of the serial cable into
the COM1 port on the back panel of your computer.
After the power is turned on, please select
All Programs
from the
Start
menu. From here
now choose
Accessories
, followed by
Communications
. In the
Communications
sub-
menu now select
HyperTerminal
.
Now start your computer and turn on the power of the GN-GT8S.
