Gigabyte GA-EX58-EXTREM, User Manual

Page: 63 / 128

- 63 - BIOS Setup
Smart Backup Config
Allows you to configure your SATA hard drives or to build a RAID array. Options are Performance
(RAID 0), Safe (RAID 1), Big (JBOD), and Normal (Port Multiplier)
(Note)
.
Apply RAID Config
After configuring the Smart Backup Config item above, press <Enter> on this item for the
settings to take effect. When the "Apply RAID Config (Y/N)?" message appears, press <Y> to
confirm. (Note: If you want to erase an existing RAID array and set up a new array, make sure
to set Smart Backup Config to Normal first, and then select the RAID mode you want.)
(Note) When the hard drive(s) is set to Normal mode, make sure to install the SATA controller driver
in the operating system for the hard drive(s) to be properly detected and to support hot plug.
This menu allows you to configure a RAID array.
Smart Backup Config
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Smart Backup Config
Item Help
Menu Level

Smart Backup Config [Performance (RAID 0)]
Apply RAID Config [Press Enter]
=== Disk Info ===
[Port] [Model]
[Capacity]
Port 0
Port 1
=== RAID Info ===
[Level] [Capacity] [Member]
Performance 0GB

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Disk/RAID Status
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Disk/RAID Status
Item Help
Menu Level

===
Disk Info ===
[Port] [Model] [Capacity]
Port 0
Port 1
===
RAID Info ===
[Volume] [Model] [Capacity] [Status]

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
This menu provides information on the connected hard drive(s) and RAID array.