Hardware Installation
- 22 -
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
20 19
2 1
10) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
Pin No. Signal Name
Definition
1
HD+
Hard Disk LED Signal anode (+)
2
MSG/PD+
Power LED Signal anode (+)
3
HD-
Hard Disk LED Signal cathode(-)
4
MSG/PD-
Power LED Signal cathode(-)
5
RST+
Reset button Signal anode (+)
6
PW+
Power Button Signal anode (+)
7
RST-
Reset button Signal cathode(-)
8
PW-
Power Button Signal cathode(-)
9
NC
No Connect
10
NC
No Connect
11
NC
No Connect
12
NC
No Connect
13 GD+
Message
14
SP+
5V Power
15 GD-
Ground
16
NC
No Connect
17
GN+
No Connect
18
NC
No Connect
19 GN-
Ground
20
SP-
Speaker Signal cathode(-)
Summary of Contents for GA-6PXSV1
Page 7: ...7 42 CPU_FAN1 CPU fan cable connector 43 SYS_FAN1 System fan cable connector...
Page 38: ...BIOS Setup 38 2 2 2 CPU Configuration...
Page 44: ...BIOS Setup 44 2 2 5 Super IO Configuration...
Page 47: ...47 BIOS Setup 2 2 7 Serial Port Console Redirection...