4
English
TA Series User’s Manual
4
3.
System equipment installation
Unload case
Step 1: Remove the screw from the bottom of the case.
Step 2: Grasp the handle on the panel and pull out the case.
Installing hard drive
Step 1: Fix the hard drive on the base with screws and connect the hard drive with the IDE
ribbon cable.
Screw stands (Attention! Install hard drive on top of the screw stands on the base.)
(Attention! Make sure that the red (fool-proof) wire on the ribbon cable should be connected to PIN 1 of the hard drive as shown
below.)
Red (fool-proof) wire should be connected to PIN 1.
TA manual ENG.p65
5
TA Series User’s Manual
5
English
Pin 1
Step 2: Fix the hard drive with its rack on the four posts and connect the ribbon cable to the
IDE connector (J1).
I
nstalling DOM (DISK On Module)
Step 1: Install DOM on the DOM slot (J1).
Attention! Make sure that DOM and HDD cannot be used at the same time.
Installing DOC (Disk On Chip)
Step 1: Install DOC on the DOC slot (U12)
Attention! Use 3.3V DOC.
