4 GREAT VIEW AVENUE NORTH. PROVIDENCE, RI 02904 401.226.5299
OPERATION INSTRUCTIONS:
CARE:
The Alana is made from heavy gage powder coated steel with an anodized or
chrome plated faceplate. The unit is best cleaned with a damp cloth, but the
faceplate may be polished with an appropriate metal polish and the main chassis
polished with an automotive wax. Care must be take not to allow either pol-
ishing dust or particles to enter into the unit through the vent holes.
Opperation:
Once the Alana is properly connected to power, source, and your amplifier, it may
be turned on using the “POWER” switch. To avoid source turn on noise, it is best
to turn the Alana on after the source is powered and before the amplifier is turned
on. The LED above the switch will light when the power is on. The volume should
not be turned up until it has had a couple minutes to warm up and stabilize.
The “VOLUME” switch is located in the middle of the faceplate. The remote control
reciever is located just above it. The “SOURCE” switch is on the far left and is used
to select between different input sources.
When first powered on, the display will show “15”. This corresponds to the volume
setting. Pressing “UP” on the remote or on the volume switch will increase the
volume and “DOWN” decreases it. The Maximum setting is “84” and the minimum
setting is “00”.
If “LEFT” or “RIGHT” is pressed on the remote, that channels volume setting will be
displayed for one second and then the display will return to the current volume
setting. To reset the balance, adjust the balance until there is no change in the
display setting after the one second, reduce both channels to “00”, or turn power
off.
If the source is pressed on the remote, or the source switch is pressed up, the
input source will increment from one to four. The corresponding input on the
back will be selected. The current source will be displayed for one second, then the
new source will be displayed for one second. The display will then return to the
voume setting.
Pressing “MUTE” on the remote or down on the “SOURCE” switch will toggle
between the current volume setting and “00”.