LaneLED INOX42
Page 15 / 22
Created
22.03.2017
roen
Modified
11.07.2018
roen
Object-ID
845816
6 Detailed installation information
6.1 Press current collector onto the system cable with special crimping pliers
Note
The current collector must be at a distance of approx. 20 cm from the end of the LaneLED light bars. Install the
contact element on the connector side towards the middle of the LaneLED light bars.
Observe the following steps:
-
Insert metal bracket into lower plier jaw, with the
contact element in the upper plier jaw.
-
Insert the system cable into the metal bracket
and turn it until it lies flat in the bracket. The
negative pole (white marking) must be aligned
toward the front of the pliers and correspond
with the + and - imprints on the sides of the
pliers. Operate the crimping pliers.
-
Insert the LaneLED connection cable (with the
white marking aligned upwards) into the current
collector until it stops. If the system cable was
previously connected to a 24 VDC supply, the
LaneLED light bars must now illuminate.
