Gibson 66538 Instruction Manual Download Page 2

EXHAUST INSTALLATION #66538 

 

When installing this exhaust system make sure to use proper safety precautions. Use jack stands 
when under the truck, set parking brake, block tires and use safety glasses and gloves.  

DO NOT WORK WITH HOT PIPES! 

 

SUGGESTED TOOLS: 

½”, 9/16”, 15mm wrench and socket, WD-40, Hacksaw, Jack Stand

 

 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Lay out the exhaust on 

the floor so it looks like 

the drawing and compare 

parts with manual. To 

remove the stock exhaust 

un-bolt it from the tailpipe 
and then remove it, next 

un-bolt the clamp that is 

located after the Y-pipe.  

Leave all rubber 

grommets in place.  Use 

WD-40 to aid in removal 

of exhaust and the 

hangers. 

Install muffler #B onto 

head pipe  1-1/2” to 2” 

with the louvers facing 

towards the converter. 

Use a jack stand to 
support the muffler 

(make sure its level). Use 

clamp  #G  to secure the 

muffler to the head pipe. 

Do not tighten.

 

Muffler inlet is looking 

into the louvers. 

Install the passenger 

side over axle tailpipe # 

 C  into the muffler (1-

1/2” to 2”).  Use clamp 

# F  to secure tailpipe 

to muffler

.  Do not 

tighten. 

 

 

 

 

 

 

Install the stainless 

tips. Clamp down. To 

clean your stainless 

tips use any stainless 

cleaner.  Now go back 
and tighten all clamps, 

nuts and bolts. Start 

from the front and 

work back. 

MAKE SURE YOU HAVE A 1” CLEARANCE ON ALL RUBBER 

BRAKE LINES, SHOCK BOOTS, TIRE, FUEL LINES, ETC.  

Install head pipe # A 

onto you’re existing stock 

front pipe and secure with 

clamp # F .  Insert 

welded hanger into 

rubber grommet. 

Do not 

tighten. 

 

 

 

 

 

 

 

 

Install driver side over 

axle tailpipe # D  into 

muffler and attach 

using clamp # F .  Use 

bolt kit #  H to attach 

the tailpipes together. 

Do not tighten. 

The 

driver side tailpipe tab 

will be on the bottom. 

Reviews: