Giant-Vac TLG101651KH, Operator'S Manual

Page: 6 / 12

3
UNIT OPERATION AND TRANSPORT
STARTING THE ENGINE
IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way
meant to replace or supersede engine manufacturer’s operating instructions. In order to obtain optimum
performance from your engine, refer to your engine manual.
BEFORE STARTING ENGINE:
•
Be sure that the unit is completely assembled, all fasteners are tightened securely, and all safety
guards and components are in place.
•
Be sure to check engine’s oil and gasoline* . (See engine manual for recommended oil and
gasoline specifications.) Never check the engine while it is running or while you are smoking.
Check only when engine is cold.
* All machines are shipped without oil or gasoline unless otherwise noted.
•
Be sure that fuel valve on engine is set to open position (if applicable).
TO START ENGINE:
•
Set throttle control to “ON” position. If engine is cold, set choke (if so equipped). If your engine
has a fuel prime button, depress it firmly three times.
•
Grasp recoil handle and pull briskly. You may have to pull several times before engine starts. (If
engine fails to start within a reasonable amount of time, discontinue and check engine manual for
further instructions.)
•
After engine starts, move throttle control down to approximately half, and turn off choke.
TO SHUT ENGINE DOWN:
•
Allow engine to idle for 2-3 minutes before shutting down.
•
Set throttle control to ‘off’ position.
•
If engine is not to be started for a prolonged period, turn fuel valve to closed position.
IMPORTANT NOTE : If you experience problems with your engine that cannot be satisfactorily resolved by
following the instructions contained within the engine manual, contact your local engine dealer, or call the toll-
free service number listed in the repair section of the engine manual. All engine service, warranty or otherwise,
is required to be performed by a manufacturer-authorized service center. Giant-Vac, Inc. is neither authorized
nor responsible for any type of warranty engine service, nor is it equipped to perform any such service.
3
UNIT OPERATION AND TRANSPORT (cont.)