Giant-Vac GIANT-BLO JR. 52, Operator'S Manual, Page: 4 / 9

UNIT OPERATION
STARTING THE ENGINE
IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no
way meant to replace or supercede engine manufacturer’s operating instructions. In order to obtain
optimum performance from your engine, refer to your engine manual.
BEFORE STARTING ENGINE:
•
Be sure that the unit is completely assembled, all fasteners are tightened securely, and all
safety guards and components are in place.
•
Be sure to check engine’s oil and gasoline* . (See engine manual for recommended oil and
gasoline specifications.) Never check the engine while it is running or while you are
smoking. Check only when engine is cold.
* All machines are shipped without oil or gasoline unless otherwise noted.
TO START ENGINE :
•
Set throttle control up to full position. Depress fuel prime button firmly three times. (Fuel
prime button is located on side of engine, below muffler)
•
Bracing blower with left hand, grasp recoil handle and pull briskly with right. (You may have
to pull several times before engine starts. If engine fails to start within a reasonable number
of attempts, discontinue and check engine manual for further instructions.)
•
After engine starts, move throttle control down to half.
CAUTION!
Blower impeller is mounted directly to engine shaft; starting engine will
immediately result in high velocity air discharge. Be sure discharge chute is directed
away from people, animals and objects when starting engine.
TO SHUT ENGINE DOWN :
•
Allow engine to idle for 2-3 minutes before shutting down.
•
Set throttle control down to ‘stop’ position.
IMPORTANT NOTE : If you experience problems with your engine that cannot be satisfactorily resolved
by following the instructions contained within the engine manual, contact your local engine dealer, or call
the toll-free service number listed in the repair section of the engine manual. All engine service, warranty
or otherwise, is required to be performed by a manufacturer-authorized service center. Giant-Vac Mfg.,
Inc. is neither authorized nor responsible for any type of warranty engine service, nor is it equipped to
perform any such service.
3