Installation Steps
Copyright © 2016 All Rights Reserved. P-MU-GK460 Published: 2017.03.31
Please ensure that there is no back pressure on the keeper from the latch. As with most strikes this may cause the strike
to bind and malfunction. It could also cause undo pressure on the solenoid and eventual failure of the strike.
Note
Place the wire inside the connector and use
pliers to press down on the head of the
connector evenly.
Installing the Crimp Connectors
Connect to the power and test the
electric strike before finally mounting
the unit
Mark the position of the latch bolt on
the door jamb as shown in figure
Align the installation template
to the marked line
Measure the vertical and horizontal position
of the latch bolt on the door leaf
Installation on Wood and Hollow Metal Frame:
Drill and cut the frame according to
the template
6
5
Install the mounting tabs
4 7/8" (123.8mm)
3 3/8" (85mm)
3/16" (5mm)
Fail-Safe when
"1" facing up
Fail-Secure
when " 2"
facing up
*Factory default setting is Fail-Secure.
2. Reverse the round screw.
3. Put back the round
screw and plug.
Fail-Safe / Fail-Secure Reversible
1 1/4” (31.75mm)
3 3/8”(85mm)
(5mm)
3/16”
4 7/8” (123.8mm)
1 1/4" (31.75mm)
(5mm)
3/16”
1. Remove the plug and
take out the round
screw.
