6
5
2.1 Processor
·
·
2.2 Memory
·
·
2.3 BIOS
·
·
·
·
2.4 Interfaces for peripherals
·
·
·
·
·
·
·
·
·
2.5 Power management
·
·
2.6 Expansion slot
·
2. Features
On-board Intel® Atom™ Processor D525;
2. On-board Next Generation NVIDIA® ION™ GPU, 512MB VRAM.
Supports 200-Pin DDR2 800/667/533MHz memories * 2;
4GB at maximum; (2GB/per slot).
Supports PNP, APM and ATAPI;
Supports ACPI and DMI;
Automatic detection and supporting hard disk whose LBA mode is over 160G;
End-users can easily upgrade the motherboard with BIOS.
Two SATA2 HDD port;
One HDMI digital interface;
One DVI interface;
Six high-speed transmission ports (max. 480Mb/s) which support USB2.0
and are compatible with USB1.1;
One RJ45 network interface (PCIe Gigabit Ethernet);
On-board HD-AUDIO audio adapter;
Interfaces on panels can be compatible with HDD LED, Speaker, etc;
One CMOS contact pin;
One system FAN socket.
Support APM and ACPI;
Compatible with energy star “Green PC”.
Two MINI-PCIe slot.
Warning
·
·
·
·
·
The motherboard consists of a great number of ICs and other components.
These ICs might be damaged by the static charge. Therefore, the user must
make the following preparations before installation:
Turn off the power of the computer. It is preferable the power cord be
unplugged.
Take care not to contact the metal wires and theirs joints on the motherboard
when handling it.
It is preferable that the operator wear the anti-static wrist strap when handling
the IC components.
Before the ICs are installed, the components of the motherboard should be
placed on the anti-static mat or bag.
When you remove the plug on the ATX power supply of the motherboard,
make sure the switch of the power supply is in OFF state.
Installing the motherboard onto the computer case:
For most of the computer cases, the multiple fixing holes left on their bottoms
can be used for securing the motherboard and preventing short circuit. During
your operation, take care not to allow the screws to contact any circuit or part on
PCB. When circuits on the surface of the motherboard get close to the fixing
holes, you can use the plastic sheet to separate the screws from the board
surface so as to avoid damage or failure of the motherboard.
II. Hardware installation
www.giadatech.com
