6
7
IDENTIFICATION OF PARTS
Power Cord and plug
Continuous drain hose outlet
Power cord buckle (placed in the water bucket,
used only when storing the unit. Installed as
shown Fig.3a))
Front
Rear
Caster
Identification of parts
Fig.2
Fig.3
Control panel
1
2
3
4
5
1
2
3
4
NOTE:
All the pictures in the manual are
for explanation purposes only. The actual
shape of the unit you purchased may be
slightly different, but the operations and
functions are the same.
OPERATING THE UNIT
When using the unit
When first using the dehumidifier, operate the unit
continuously 24 hours. Make sure the plastic cover on
the continuous drain hose outlet install stightly properly
so there are no leaks.
This unit is designed to operate with a working
O
O
O
O
environment between 5 C/41 F and 35 C/95 F.
If the unit has been switched off and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
Make sure the Water bucket is correctly fitted otherwise
the unit will not operate properly.
NOTE:
When the water in the bucket reaches to a certain
level,please be careful to move the machine to avoid it
falling down.
Casters(At four points on the bottom of unit)
Casters can move freely.
Do not force casters to move over carpet,
nor move the unit with water in the bucket.
(The unit may tip over and spill water.)
A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
20cm or more
20cm or more
40cm or more
20cm or more
40cm or
more
Positioning the unit
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidifier should not be used
for commercial or industrial applications.
Place the dehumidifier on a smooth, level floor strong
enough to support the unit with a full bucket of water.
Allow at least 20cm of air space on all sides of the unit
for good air circulation (at least 40cm of air space on
air outlet).
Place the unit in an area where the temperature will not
fall below 5 C(41 F). The coils can become covered with
frost at temperatures below 5 C(41 F), which may reduce
performance.
Place the unit away from the clothes dryer, heater or radiator.
Use the unit to prevent moisture damage anywhere books
or valuables are stored.
Use the dehumidifier in a basement to help prevent
moisture damage.
The dehumidifier must be operated in an enclosed
area to be most effective.
Close all doors, windows and other outside openings
to the room.
Fig.4a
Accessories:(placed in the water bucket of the unit)
pump drain hose(1pc) (only for the unit with pump featrue)
power cord buckle(1pc) female threaded end(1pc)(on some models)
Pump drain hose outlet(some models without)
5
1
3
4
5
2
1
2
3
5
4
6
7
Panel
Water bucket
Water level window
Handle (both sides)
6
7
Air outlet grille
Air filter
Insert the power cord buckle
into the unit.
Fig.3a
Air outlet grille