The top can be identified by the 1 inch wide rib.
The outside can be identified by the rounded corner.
The top can be identified by the flat top
that travels the length of the frame.
Aligned & attached
3.
Place the Center Frame between Left and Right Side Frames with the
flat full length side facing up. Please note that the Twin and Twin Long
foundations do not use a center support, so skip this step, if need be, and
continue with step 4.
2.
Place the Left Side Frame and the Right Side Frame with the 1" wide
rib upward and to the outside.
4.
Unroll one Slat Bundle. Note that the first slat (top cross rail) is longer
than the others. Attach one corner of the Top Cross Rail to one corner of
the Side Frame using two wood screws. Make sure the slat is flush all
around. Align other Side Frame and fasten using two wood screws. Align
Center Frame and fasten using one wood screws. Align and attach the six
Slats with three wood screws per slat at pre-drilled locations. Make sure
the slat is flush all around and the fabric stitching the slats is facing up.
Align other Side Frame and fasten using two wood screws.
6.
Carefully turn the foundation over so the Slats are flat on the floor.
Attach Bottom Cross Rails to the corners of the Side and Center Frames
making sure they are flush all around. Attach bottom cross rails using five
wood screws per rail.
5.
Unroll remaining Slat Bundle. As was done with previous Slat Bundle,
attach Top Cross Rail to Frame ends using five wood screws. Make sure
the Top Cross Rail is flush all around. Align and attach the six Slats with
three wood screws per slat at pre-drilled locations.
7.
Once again, turn the complete foundation over so the Slats are facing
upwards. Unfold the cover and pull it over and around the foundation.
Ensure the corners are aligned tightly and the entire foundation is
covered.
Nature’s Sleep KD-Foundation® Assembly Instructions Made in USA
