30
P U L L - T O - O P E N
© G h o s t C o n t r o l s
®
2 0 2 1
STEP 14A. FOR TUBE GATES attach the tube gate bracket to the gate. The gate must remain in
the desired open position.
OPEN THE GATE TO THE DESIRED OPEN POSITION
A. Attach the gate bracket assembly to the fully retracted operator as shown. Insert the supplied 10mm x 40
mm clevis pin, 10mm I.D Nylon Spacer, and clevis hairpin through the front of the operator and gate bracket
to secure the bracket onto the front mount of the gate operator.
WARNING
DO NOT SCREW THE OPERATOR ARM IN OR OUT TO ADJUST YOUR GATE POSITION. DOING SO
CAUSES THE SYSTEM TO NOT FUNCTION PROPERLY.
B. Now install the pre-assembled tubular clamp bracket over the center-most bar on your tube gate with the
gate at the open position.
C. Insert (2) M8 x 65mm flat washers, and (2) nylon locknuts as shown below through the tube gate bracket and
TIGHTEN NUTS TO SECURE THE TUBULAR CLAMP BRACKET TO THE GATE.
