STEP 1. UNDERSTANDING THE LEDS UNDER THE COVER
RED LED:
■
Blinking = A Ghost Controls
®
signal is received (the signal may or may not have been programmed to the receiver)
■
Solid = Receiver is in LEARN mode
YELLOW LED:
■
One Blink = A valid Ghost Controls
®
signal is received and the “cycle” relay is momentarily activated for half a second
■
OFF = “CYCLE” relay is off
GREEN LED:
■
ON = A valid PartyMode
®
or exit Ghost Controls
®
signal is received and the “OPEN” relay is on/activated
■
OFF = “OPEN” relay is off
STEP 2. HOW TO TEACH YOUR RECEIVER TO LEARN THE NEW REMOTE TRANSMITTER
1. Press and hold the
LEARN
button on receiver until the unit beeps and the
RED LED
stays on.
2. Release the
LEARN
button. The
RED LED
will stay lit to indicate that it is in
LEARN
mode and waiting for the signal from the
remote transmitter.
3. Press and hold the
or
button on the GHOST CONTROLS
®
remote transmitter until you hear a beep and the RED LED
on the receiver turns off. The transmitter is now programmed into the receiver and controls the access control system or gate.
4. Confirm that the transmitter activate the CYCLE relay by observing that the YELLOW LED blinks once with each press of the
transmitter.
5. The FREE-EXIT/OPEN output is automatically programmed.
6. Confirm that the FREE-EXIT/OPEN output is operational:
a. Press and hold the
button on the transmitter until the RED LED on the transmitter stays lit.
b. Press the transmitter’s button in # 3 above.
c. The receiver’s FREE-EXIT/OPEN output and GREEN LED should turn ON and stay ON.
d.
Repeat a and b above
to turn the receiver’s FREE-EXIT/OPEN output and GREEN LED OFF.
IMPORTANT
If you have a wireless keypad or additional transmitters, you can now use this programmed/learned remote to program them.
PLEASE REFER TO THE KEYPAD OR TRANSMITTER MANUALS FOR DETAILS OR OUR WEBSITE
GHOSTCONTROLS.COM.
