HD2050
- 15 -
V1.2
Fig. 12 –mounting the
loudspeaker on the sup-
port
The support has two screws with knob for each side (see figure
above). The screw with the larger size is coupled to a female
thread in the rear panel of the case. The coupling hole is posi-
tioned under the compartment for electrical connectors. The
same type of connection is also present in the upper part of the
case.
The two screws with smaller knob, instead are used to disas-
semble the aluminum support in case of transport.
Once the loudspeaker is assembled with the support, it can be
positioned on the floor or installed on the stand as shown in
Fig. 14.
NB: When the loudspeaker is installed on the stand,
make sure that it is properly positioned with the legs ex-
tended; an incorrect positioning of the stand and the
loudspeaker may damage the instrument itself as well as
cause personal injury to user.
When the tripod is used with the pole to its maximum
extension make sure that the floor is sufficiently flat to
ensure the stability of the system.
The HD2050.30.2 aluminum support disassembled is divided in
three parts as shown in the figure below.
Fig. 14 –HD2050.30.1 support disassembled
Fig. 13 – loudspeaker
installed on the tripod
using HD2050.30.2 support
