E44.X.01.6C-04
Mounting- and Operating Manual GIR 300
page 12 of 34
5.3.7 Connecting a counter signal
When configuring the device you can select 3 different input signal modes similar to the connection of
frequency- and rotation-signals
.
The connection of a sensor-signal for a counter-signal is the same used for the frequency- and rotation-
signal
.
Please use the wiring diagram given in this chapter.
There is the possibility to reset the counter. When connecting contact 4 with GND (e.g. contact 6) the
counter will be reset. You can do this manually (e.g. with the help of a push-button) or automatically
(with one switching output of the device).
When connecting the device, take care not to exceed the limits of the input-
voltage or the input-current of the frequency input.
+
_
9-28 VDC
Supply:
-Uv
Sig.
+Uv
transducer
Impulse
8
7
6
5
4
Res et-
button
-Uv
Sig.
+Uv
transducer
Impulse
_
+
9-28 VDC
Supply:
no.2
device
8
7
5
no.1
device
12
11
8
7
5
4
Manually reset the device
with the help of an push-button
+
_
9-28 VDC
Supply:
-Uv
Sig.
+Uv
transducer
Impulse
12
11
8
7
6
5
4
Res et-
button
automatically resetting with the help of output 1 and
additional resetting the device via push-button
Connection note: output 2 can only be used to
switching of low voltage potential!
Cascading of GIR 300
(Configuration note for the GIR 300:
device 1
– input signal like impulse transducer
device 2
– input signal = switching-contact
