background image

GUIDE 

GROOVE

Board Mounting Hole

(Mark for pre-drilling)

Position 

screw in 

the center 

of slot

5' Porcelain Board Hanging Instructions

Note: This installation guide is used for boards of 

different sizes. Due to the variances, you may receive 

more hanging hardware than required for your board. 

Please be sure to read all instructions before 

installing your whiteboard. 

STEP 1

Align the tray end caps with each end of the tray and firmly 

push them onto the accessory tray. 

See Illustration 1.

STEP 2:

 

Determine the desired height from the floor to the bottom of 

the board. Scribe a level line on the wall at that distance. Position the 

bottom edge of the accessory tray along this line. Using the groove at 

the rear of the accessory tray as a guide, pre-drill 1/8" diameter holes 

through the accessory tray. Fasten the accessory tray to the wall using 

the appropriate hardware for the mounting surface. 

See Illustration 2.

STEP 3:

 

Lift and center the board on the mounted accessory tray / L-

hangers. Scribe a line on the wall along the top edge of the board. 

Remove the board and position the top edge of two L-hangers along this 

line 6" from the edge of the board. 

NOTE:

 Place each screw in the 

center

 of each L-hanger's slot. 

Fasten each L-hanger to the wall using the appropriate hardware for the 

mounting surface. Be sure not to over tighten the top L-hangers, as this 

may affect Step 4. 

See Illustration 3.

STEP 4:

 

Tap the L-hangers up until the screw is resting in the lower 

end of the hanger's slot. Place the board onto the accessory tray / L-

hangers and tap the top L-hangers down against the frame. Using the L-

hangers as a template, mark all the board mounting hole locations 

(including lower L-hangers if used). Remove the board. Drill 1/8" 

diameter holes at each of the marked locations and reattach the board 

with the #8 x 1/2" screws provided.

See Illustration 4.

STEP 5 (Required for 11/16" thick boards ONLY):

Push the bottom of the board against the accessory tray/ wall. Drill 1/8" 

diameter hole into the frame using the holes in the accessory tray as a 

drill guide. Install #8-1" screws on each end of the tray.

WWW.GHENT.COM - LEBANON, OH - 800-543-0550

IS-M1P5-PB 05/21

1

2

3

4

5

Reviews: