51
17. Initializing of the software of the MLW
If a previously-saved position is no longer properly set, you may have to initialize the
software. To correct the differences of position, you have to carry out the following
steps:
I
NITIALIZING
:
T
HE
MLW
MUST BE DRIVEN IN THE FOLLOWING POSITION
(
S
.
BELOW
,
FIG
.
11):
F
IG
.
11
(Fig. similar: Fig serves as an example only)
P
ROCEED AS FOLLOWS
:
1.
The
backrest motor
must be set to
max
. position. The backrest must have an
angle of 75
0
to the seat! (
button
3
of the manual control panel / s. below, fig. 12).
2.
The
other motors
must be set to
min
. position; that means:
a.
The height-motor (work height) must be set to its lowest setting! (
button
2
of
the manual control panel / s. below, fig. 12).
b.
The inclination-motor (thigh-area) must be level to the leg section (calf-area),
i.e. it has to be adjusted horizontally.
Caution!
Keep pressing the
button 6
of the manual control panel (s. below,
fig. 12)
until the motor is switched off
.
c.
The motor of the leg section has to also be set to min., i.e.
keep pressing the
button 8
of the manual control panel (s. below, fig. 12)
until this motor is
also switched off
; it is clearly audible.
❖
The initializing is completed after having reached the last above described
positions.