EN - 16
14. TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
SOLUTION
1.
The cutting means
is stationary and the
machine does not start
when the throttle control
lever and throttle safety
lever are engaged
Battery is not inserted or
is inserted incorrectly
Make sure that the battery is
inserted correctly (par. 7.2.3)
Low battery
Check the battery status and
recharge if necessary (par. 7.2.2)
The separable rod was not fully or
properly inserted in its housing
Make sure the separable rod was
installed
and correctly inserted (par. 4.2)
Defective throttle control lever/
throttle safety lever
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Machine damaged.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
2. Motor overheating
Grass caught under the
cutting means guard
Remove caught grass (par. 6.5)
3.
Grass accumulates
around the power
unit housing and the
cutting line head
Too high grass is being cut
close to the ground
Cut tall grass with a top down
movement to avoid accumulations.
4. The line is not released
when the automatic
release is turned on
The line is stuck to itself
Lubricate with silicone spray
Not enough line on the
reel or reel empty
Replace the reel (chap. 8.1.1)
or the line (chap. 8.1.2)
The line is worn and too short
Release the line manually (chap. 6.4.2.)
The line is tangled on the reel or broken Remove the line from the reel
and
rewind it (chapter 8.1.2)
5.
The cutting means
comes into contact
with a foreign body.
-
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
6.
Excessive noise and/or
vibration is experienced
whilst working
Loose or damaged parts.
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
7.
The machine gives off
smoke whilst working
Machine damaged.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
8. Battery power
reserve is low
Severe working conditions
requiring greater
current absorption
Optimise operations
(par. 7.2.1)
Battery is insufficient for
operating requirements
Use a second battery or
extended
battery (par. 15.1)
Decrease in battery capacity
Purchase a new battery
If problems persist after having performed the above operations, contact your dealer.
Summary of Contents for TR 24 Li
