GGM gastro 200 SCN, Operating Manual

Page: 7 / 24

WARNING!
•
•
•
•
•
•
•
•
•
•
•
•
•
PICTURE 1 PICTURE 2 PICTURE 3
You must clean inside your product before the first use.
Do not place your product to a place exposed to direct sunlight or influence area of the heat sources
such as stove, radiator core, oven, cooker, radiant and infrared. Otherwise, this may cause
performance decrease, damage of device or make it become dysfunctional. (Picture 1)
In case of prolonged blackouts, do not open the door of your products for preventing heat loss. If
you do not use your device or leave it empty for a short time, do not unplug it for saving energy.
Otherwise, more energy will be consumed for retooling your product.
In products, the doors of which are left opened or opened and closed continuously, frost deposit
will increase and no cooling operation will be carried out. Thus open the doors only when needed.
Make sure that the doors are closed if not required.
Unplug your product in case of sudden blackouts. For starting again, plug in your product 10
minutes after the electricity is supplied. High voltage occurring at the moment of electricity
supply may cause damage of your cabinet and fire.
Do not allow wild animals and pets to enter into your product or walk around it. It may damage your
product or cause death and injury ofthe animals. Furthermore, wild animals and pets may cause fire
by giving harm to the electrical installation.
Your product is set for operating at mains power of 220-240 Volt 50-60 Hz.Using your product with a
different voltage may cause it become dysfunctional and fire. (Picture 2) Please check rating label on
your device.
Our company is not responsible for the failures and damages that may occur in case of using
without grounding.
Pack your foodstuff airetight before placing them into your product for preventing them losing their
tastes and not getting dry.
Electrical installation must conform to national regulations. (Picture 3)
There must absolutely be a residual current relay and a fuse in your electrical installation for
preventing the risks of electrical shockand fire.
Place the device in a damp-free place with unobstructed air circulation.
After placing your device to its place, wait for 3 or 4 hours without moving it before starting using.
220- 240 Volta
50
-60
Hz.
A- THINGS THAT MUST BE DONE BEFORE USING YOUR
PRODUCT AND SECURITY WARNINGS