Using your headset with multiple Bluetooth devices
25
26
current pairings.
1. Short press and release all the three buttons on your headset and the duration is less than 1
second. You can see the purple indicator quickly flash twice then the blue indicator and the red
indicator cross blink per second, your headset go into pairing mode automatically after resetting.
You can only reset your headset when it is in standby mode (please refer to the LED indicator
chart).
2. Pair the Bluetooth device with your headset.
To answer a call
When your headset have a Bluetooth link with one of the paired phones, and the other paired phone
rings, you can answer this call follow these steps:
1. Release the Bluetooth connection with current device by short pressing MFB
and Volume down
button
at the same time.
2. After your headset get into standby mode(please refer to the LED indicator char), press the
MFB
n times to answer the call through the n'th paired phone.
your headset takes time to set up the Bluetooth connection with the n'th phone. If you hear
the ring tone from your headset, just short press MFB
again to answer this call.
3. End the call by short pressing the MFB
.
To make a call using voice dialing
1. Make sure your phone support this function and is on.
2. Make sure your headset and your phone are both powered on and within range of each
other.
3. Voice dialing through the current connected device by short pressing the MFB
1 time
on your headset.
Note:
Short press the MFB
n times to voice dial through the n'th paired device when not
connected. It may take a while to set up the Bluetooth connection if the Bluetooth
