Operating Precautions
The printer is for use only in a room that fits for sensible
electronic parts.
Please use the cable that is delivered together with the printer.
Disconnect the power cable before you open the printer.
Changing Parameters for Serial Interface
Serial Interface RS232
You can change all parameters, if necessary, by using the DIP-switch
setting on the controller board.
The controller board is part of the printer module. To get to the controller
board, please remove screws from printer module and lift the printer
module carefully.
A listing of possible settings you will find on page 13.
5
Operating the printer
Interface cable
Please use the interface cable that is delivered together with this
printer.
Turn off printer and analysis system before you connect these
two devices.
Please connect data line first before you connect the power
cable.
Power Connection
Please only use the power supply adaptor that is delivered together
with the printer. Other adaptors may damage the printer.
Please insert Ithe plug into a socket of the specified voltage and put
the small round plug into the printers power input.
Please connect data line first before you connect the power cable.
6