gfm GF-Primo Dolly, Instruction Manual And Safety Manuallines

Page: 28 / 92

27
5 Electronic Unit Components
The following describes the electronic components:
:
6 Before operating the HCU and the Dolly
When the dolly arrives from the factory the HCU and electronic unit will already be paired and set up to
be switched on in either Wireless Mode or with Cable connection. The column will already be
calibrated
Should the original HCU or electronic be replaced, the new units must be paired i.e. connected with
each other. Please refer to section “ 9 Pairing the HCU and electronic unit”
Check the following before operating the dolly:

In both cable and wireless mode, ensure that the HCU battery is fully charged and inserted
into the HCU.

Check that the external antenna is inserted and connected correctly.

Emergency Off Switch must be off (extended).

The dolly wheel arms must be extended to the widest position

The complete lift and panning range of the dolly/jib must be clear of obstructions
Cover for Back Up Drive System
with Channel display
Serial number
Emergency Off Switch!
Press to deactivate
electronic!
Must be extended to
allow operation!!
Connector for Hand Control Cable On- / Off-Switch with Status-LED
External antenne