4
EQUALISYS
Multimode Parametric EQ
User Manual
In
parallel
mode the two EQs are fed with the same input signal (from
INP-1
), but their out-
puts go to seperate output terminals (
OUT-1
and
OUT-2
). This configuration is useful when
you want to apply different EQ curves to two different effect chains or amps. You can also
use Equalisys as a
splitter pedal
with individual volume control (set GAIN knob at mid-
point).
In this configuration the input output signals are totally independent, you can apply the
two EQs to two separate signal chains / amps. One convenient use of this mode is to use
the pedal for applying
pre-
and
post-equalization
to overdrive or distortion pedal, this two-
stage equalisation scheme is a powerful way to get the best out of your dirt pedals (or if
using amp’s distortion place EQ-1 before the preamp and EQ-2 in the send / return loop).
EQ-1
EQ-2
INP-1
INP-2
OUT-2
OUT-1
EQUALISYS
INDEPENDENT mode (2 EQ pedals in a box)
PRE / POST EQUALISATION
Pre / Post equalization is powerful equalising technique, basically you apply EQ
before
and after
the overdrive / distortion effect. What you have is a very tweakable tone shap-
ing of your drive sound. With Equalisys you can do pre-post equalization very easily
(without having to have 2 separate EQ pedals), here’s how :
EQ
EQ
Overdrive /
Distortion
Basic Pre/Post EQ-ing setup :
Pre/Post EQ-ing setup wth Equalisys :
use
Independent
mode to break Equalisys into 2 independent EQ pedals.
