GF NeoFlow DN200, Operating Instructions Manual

Page: 20 / 54

20
2.1 TRANSPORT AND HANDLING
Transport via the packaging provided. Do not rest regulator on control system.
►Transport and store the product in its unopened original packing.
►Protect the product from harmful physical influences such as dust, heat, humidity and UV radiation.
► The product and its components must not be damaged either by mechanical or thermal influences.
► Store the product with the lever in the open position (delivery state).
►Check the product for general damage prior to installation.
ATTENTION
All NeoFlow valves MUST be stored indoors, at room temperature and out of direct sunlight at all times.
WARNING
DO NOT LIFT via the external control system (i.e., the pilot, pilot bracket or feed tubes). Damage to these
components through improper lifting processes can lead to a loss of system integrity.
Note: Consideration should be given to sites where flooding, freezing, snow, or freezing rain may be
experienced. Additional overhead protection of the pilot regulator from weather and/or flooding should
be used where necessary.
Prior to installation, all pipes should be flushed to remove chips, scale, and debris. The regulator
should be thoroughly checked for internal or external damage.
Note: Whilst installing, ensure disinfection procedures are used on all connections to
prevent contamination.