GEZE TSA 160 NT F, Wiring Diagram, Page: 31 / 64

TSA 160 NT
31
Mode of operation
13.3 Mechanical programme switch (MPS-D, external programme switch)
à
MPS-D, AS500, mat. no. 118417
à MPS-D-ST, with key, AS500, mat. no. 118418
à Operating modes: NA, AU, DO
à Accessories:
à
Surface-mounted cap, single, AS500,
mat. no. 120503
X
Set the parameters (internal or external binary
programme switch):
à
DPS: Set
ps
automatic contact type to
value
01
for “normally opened con-
tact” (factory setting).
à
ST220: Set “Signals”, “Input signals” ,”AU” to value “normally opened contact” (factory setting).
Set “Signals”, “Input signals” ,”DO” to value “normally opened contact” (factory setting).
à
S1, S2: Set parameter 19 to value 01 for “normally opened contact” (factory setting).
X
Disconnect internal programme switch (disconnect red wire and insulate).
X
At 2-leaf systems connect to the active leaf.
13.4 Keypad programme switch (TPS)
à
TPS, AS500, flush-mounted, mat. no. 113231
à
TPS SCT, AS500, flush-mounted, with key
switch, without euro profile half cylinder,
mat. no. 113232
à Operating modes:
OFF, NA, LS, AU, DO, Summer/Winter
X
Follow the installation instructions.
à
Accessories:
à
Euro profile half cylinder, mat. no. 090176
à
Additional contact, mat. no. 024467
à
Surface-mounted cap, single, AS500,
mat. no. 120503
à Surface-mounted cap, double, AS500,
mat. no. 128609
à Operation of the TPS is only possible,
à
if no active signal is applied to Terminals
8 (AU) and 9 (DO),
à
if terminals 1–44 are jumpered or the
key push switch is triggered,
à
by unlocking by password if a password
has been configured in the Service menu.
1 LEDs for operating mode display. When a fault occurs, the LEDs
display a fault code (see chapter 25.3, “Fault messages keypad
programme switch”).
2 Display 1-leaf/2-leaf operation
(LED lights up at 1-leaf operation,
LED flashes when maintenance is due)
à Switching over between 1-leaf and 2-leaf operation:
X
Press the push buttons   simultaneously.