GEZE TSA 160 NT F, Wiring Diagram, Page: 60 / 64

TSA 160 NT
60
Fault messages
Display of passive leaf faults on the active leaf (DPS, service LEDs, ST220/GEZEconnects)
DPS Service-LEDs Fault message ST220 Fault description
5 4 3 2 1
2 3
SF - Faulty solenoid valve SF - Faulty solenoid valve
71
The faults are displayed
at the active leaf
as collective fault 11
SF - Motortriac SF - Motortriac defective
7 2 SF - Motor relay SF - Motor relay defective
7 3 SF - SIS defective SF - Testing SIS faulty or permanent activation
7 4
SF - SIO defective SF - Testing SIO faulty or permanent activation
7 5 – SF - Not assigned
7 6 – SF - Not assigned
77
SF – control DCU500
RAM test
EEPROM comparison
Motor test
CRC1
CRC2
24V fault surge voltage
SF - Internal control fault
7 8 SF – Comm. SF-GF SF - Faulty communication active leaf - passive leaf
7 9 SF – Wall blanking SF - Cam switch wall blanking defective
8 0
SF - Motor voltage SF - Fault while measuring the motor voltage
25.3 Fault messages keypad programme switch
TPS display Designation DPS display
○ ○ ● ● ○
SIS
0 3
,
7 3
● ○ ● ○ ○
SIO
0 4
,
7 4
● ○ ○ ○ ● Alarm
3 2
,
4 2
● ● ○ ○ ●
Control
01
,
0 2
,
0 6
,
07
,
0 8
,
1 0
71
,
7 2
,
7 6
,
77
,
7 8
,
8 0
○ ○ ● ○ ●
Wall blanking
0 9
,
7 9
○ ○ ○ ○ ○
No operating voltage
In addition, the following states are displayed:
à
Fault Mode of operation is displayed for 5 s, the fault message for 2 s.
à Block active Current operating mode LED flashes once if a key is pressed.