GEZE Powerturn, Installation And Service Instructions Manual

Page: 27 / 56

Powerturn
27
Installation
7.5 Hooking the drive into the mounting plate
à
The connector panel must be loosened with 5-10 mm clearance to the ceiling above, see chapter 7.6.
X
If there is insufficient space above the drive, insert the counter piece (1) and the optional spindle extension be-
fore the drive is installed (see chapter 7.12 and 7.13).
X
Hook the drive (2) into the mounting plate (3) from above.
The clamping claw (4) and the shoulder (5) of the mounting plate (3) must line up with each other for this.
X
Push the drive on the mounting plate firmly towards the door hinge (range of movement = approx. 20 mm).
X
Check for smooth movement.
X
Make sure that no cables become jammed in the connector panel.
à
When it comes to the installation of the door, the hinge-side side panel must be clipped on before the drive
is pushed in the direction of the hinge.