6
Parameter
- Operating modes
The operating mode in which this block operates is specified
in the application software for each block (movement blocks
1 - 5). The following operating modes are available:
– Normal operation
– Master mode
– Slave mode
– Monitoring mode
Depending on the operating mode different parameters and
communication objects will be displayed. Each operating
mode can operate brightness-dependently or non-
brightness-dependently.
Normal operation
In this operating mode the movement detector does not have
any external trigger objects (master trigger object, trigger
object). Telegrams cannot be sent cyclically and this means
a master-slave system cannot be set up. In the default
setting, the movement detector transmits an ON telegram at
the start of movement and transmits an OFF telegram when
the movement time (staircase timer) has expired.
|
Note:
Use the "Normal operation" setting when the
movement detector is working for itself alone. In
other words, one movement detector is used for each
room and it switches one light or one light panel.
Master mode
With master mode all of the possible parameters and
communication objects of the movement detector are
available. A master-slave system can be set up with the aid
of the master trigger object or the trigger object. In the
default setting, the movement detector transmits an ON
telegram at the start of movement and transmits an OFF
telegram when the movement time (staircase timer) has
expired.
Slave mode
In slave mode the default setting is that ON telegrams are
sent cyclically when a movement is detected. These
telegrams are intended for the master trigger object or for the
trigger object of the master.
Monitoring mode
In monitoring mode the default setting is that ON telegrams
are sent cyclically when a movement is detected. At the end
of the movement time (cycle time with movement) OFF
telegrams are transmitted cyclically.
|
Note:
Use the "Monitoring mode" setting when the
movementmovement detector is being used for room
monitoring and telegrams are to be sent cyclically on
the bus.
Block X, general brightness
Parameter
Setting
Movement detection is
brightness-dependent
independent of brightness
Brightness threshold adjustable via
Parameters
Potentiometer
Overwrite brightness threshold
during download
Enabled
Disabled
Brightness threshold (3 - 1000 lux)
see "General" tab
3 - 1000 lux; preconfiguration:
130
Brightness threshold object
Disabled
Enabled
Brightness object 1 bit
Do not send
Transmit
Transmit inverted
Always-dark object (= not
brightness-dependent)
Disabled
Enabled
Switch on at movment
Enabled
Disabled
