7
6
LED wall light CAROLINE
By purchasing this device you have opted
for a high-quality GEV product. Please read
through these operating instructions carefully
in order to ensure that the device functions
correctly. Keep these instructions in a safe
place so that you can refer to them later if
necessary.
Operation/Intended Use
The LED wall light is switched on and off via a
switch. The light can be assembled quickly and
is then immediately ready to use.
Note:
The bulbs in this light are not replaceable.
If the light needs to be replaced, for example
because it has reached operational life span, the
entire light must be replaced.
Safety instructions
This device must be installed by a
technician in accordance with the
applicable regulations. Work may only
be carried out when the circuit is de-energised.
Always switch the circuit breaker off.
Please check that the connection cable is
disconnected!
Under no circumstances does the warranty cover
damage resulting from failure to observe these
instructions. Nor do we accept liability for any
indirect damage.
Similarly, we can accept no liability for any material
damage or bodily injury caused by mishandling or
failure to observe the safety instructions. In these
cases, no warranty claim may be made.
In addition, for safety and compliance reasons,
you are not authorised to dismantle or alter the
device in any way.
Preparation
Before carrying out assembly and installation,
select a suitable mounting location. Switch the
electricity supply off
(Fig. A)
.
Note:
Mains power is supplied via a cable
containing three wires:
L = phase (black, brown or grey)
N = neutral (blue)
PE = earth (green/yellow)
The connection should be made to the L and N
wires.
If in doubt, check the cable using a voltage tester.
Installation
• Remove the light housing from the wall holder
using the appropriate tool
(Fig. B)
.
BA_10840_10833.indd 7
23.08.2017 11:36:19
