STEP 3:
1)
Secure the upper console mast to the
lower console mast using four bolts
(A1). Alternately tighten each bolt
using the Allen Wrench. Check the
console mast to make sure it is
securely fastened.
STEP 4:
1)
Feed the heart rate wires of the handlebar
through the small hole located in the front of
the console mast. Pull these wires up through
the hole at the top of the console mast. Attach
the handlebar to the console mast using four
bolts (A1). Tighten with the Allen Wrench.
2)
Remove the four mounting bolts from the
back of the console with the Phillips
Screwdriver. Plug in the wire harness and the
two heart rate wires to the back of the
console. Attach the console to the console
mast with the four bolts removed earlier in
this step.
3)
Attach the accessory tray to the console mast
using two screws (A2). Tighten them with the
Phillips Screwdriver.
