SYSTEM
REQUIREMENTS
RW-470 5
System requirements
Please read through the following recommendations carefully.
They can be very helpful in finding the optimum hardware for
your needs.
•
Operating system
:
Microsoft Windows 2000 Professional
with ServicePack 1 or
higher
•
Processor
:
Pentium III, 800 Mhz or higher.
•
PCI Bus:
The PCI bus system must meet up-to-date standards (PCI 2.0
or higher – 3.3 V or 5 V autoadaptive, maximum load 5 A).
If your computer does not fulfill this standard, it is possible
that the plotter controller will not be identified.
•
Front Side Bus:
133 Mhz
•
System memory
:
Use a system memory with at least 256 MB RAM. With this
system memory, you can plot or scan the maximum drawing
size. However, a system memory of 512 MB RAM is recom-
mended if you wish to simultaneously plot and scan draw-
ings with maximum drawing size. Simultaneous scanning
and plotting of smaller formats also enables the use of
smaller system memory. See also page 6.
•
Hard drive
:
The hard drive should have at least 10 GB memory. We rec-
ommend not to install the program on that drive where you
have already installed your operating system.
•
Network interface/Configuration
:
10/100 Base T Ethernet, the TCP/IP configuration is neces-
sary
•
RW-470 Controller:
Physical dimension: 190 mm x 128 mm
PCB dimension: 174,63 mm x 106,8 mm
