Gesipa PowerBird Pro Gold Edition, Operating Manual With Spare Parts List

Page: 21 / 160

21
GB
2.8 Environmental protection
4. Troubleshooting
4.1 Blind rivet cannot be set
Cause Remedy
No battery Charge battery; replace if necessary
Jaws dirty or worn Clean them and lubricate or grease the
sliding surfaces or replace them (see 2.7)
Jaw assembly loose Tighten (see 2.7)
If batteries need to be replaced, please observe the following:
• Return used GESIPA
®
rechargeable batteries to your dealer or to GESIPA
®
for recycling.
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2014/30/EC (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial num-
ber it can be returned free of charge to GESIPA
®
for correct disposal.
2.9 Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
3. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the riveting tool. In case of doubt, always send the riveting tool back to the supplier
or to GESIPA
®
.
You can find the spare parts for your tool online at www.gesipa.com.