Maintenance:
The RV74G installation tool has been engineered to provide trouble free operation under normal
usage conditions. No lubrication is necessary unless the tool has been disassembled. Upon
reassembly, pack the RV74G tool with
Keystone Zeniplex 2 grease
.
The pulling head will require periodic cleaning. A small rifle brush passed through the jaws will
maintain the efficiency of the tool. Occasionally disassemble the entire pulling head and clean
thoroughly, paying special attention the jaws. Upon reassembly, lubricate the inside conical
surface of the collet sparingly with a light chassis lubricant. Refer to the applicable pulling head
drawings.
Caution:
DO NOT operate the tool on a current with voltage outside the specified limits. To do so may
seriously damage the tool.
Extension Cord Selection:
If an extension cord is used, make sure the conductor size is large enough to prevent excessive
voltage drop that will cause loss of power and possible motor damage. Also if used outdoors, use
only extension cords approved for outdoor use.
Amperage Rating
25 feet
50 feet
100 feet
More Than
Not More Than
AWG
0
6
18
16
16
6
10
18
16
14
10
12
16
16
14
12
16
14
12
Not Recommended
WARNING:
When using electrical tools, basic safety precautions should always be followed to reduce the
risk of fire, electric shock and personal injury.
Keep work areas clean to prevent injuries.
DO NOT expose the tool to rain. DO NOT use in damp or wet locations. If water or fluids enter
the motor, discontinue use and send the tool in for repair. Keep work areas well lighted. Avoid
chemical or corrosive environments. DO NOT use tool in presence of flammable liquids and
gases.
Prevent body contact with grounded surfaces.
When tool is not in use, it should be stored in a dry place.
DO NOT wear loose clothing or jewelry.
Summary of Contents for Olympic RV74G
Page 4: ......
