4
Satellite tracker
E L E C T R O N I C S E C U R I T Y S Y S T E M S
ALARM
ALARM
5. Installing the SIM card
Use the supplied screwdriver to open the back
cover of the locator; insert the SIM card into
the SIM card slot. Ensure that the SIM card
is configured for the GSM network, is able
to display the caller’s number, has no call
forwarding enabled and that the PIN code is
unlocked. The SMS format must be in TXT
format; the locator does not recognise PDU
format. Connect the positive (red) and negative
(black) cable to the vehicle’s power supply
system (see paragraph 7. Installation of the
device), wait 1 minute after connection for the
localiser to activate and operate normally; then
switch on the backup battery switch.
After checking everything, close the device
compartment.
6. Function of LEDs
When switched on, the LEDs on the top of the front panel illuminate.
The central red LED with the battery symbol lights up steadily during charging, otherwise it is off and
will flash only when the backup battery is low; the backup battery intervenes in the event of a main
power failure and provides about 12 hours of autonomy.
The blue LED with the satellite symbol will flash every second if there is good GPS signal coverage;
if there is no GPS coverage the LED will remain off.
The green LED in GSM mode will blink every second if there is sufficient network coverage, and
in GPRS mode the LED will blink every 3 seconds; if there is no network coverage it will be lit
continuously.
7. Installation and positioning of the device
N.B.: N.B.: Have the device installed by qualified personnel. Do not install in
a location that restricts the GSM function. Install away from dust, water and
moisture. This device is equipped with a motion detector (triaxial accelerometer)
and a schock sensor. It is essential to fix the device properly to a rigid support
inside the passenger compartment, taking care to conceal it from view, if possible
on the longitudinal axis of the vehicle (highlighted with the dotted line in the
image) and at the front of the vehicle (highlighted with the circle in the image).
7.1 Simple electrical connection
If you only want to use the device as a locator, connect the cables:
• RED (+)
• BLACK (-)
• WHITE (+15)
7.2 Connection to RAPTORalarm control panels
• RED (+)
• BLACK (-)
• WHITE positive alarm input: connect to the WHITE/GREEN
wire of the 8-way connector of the RAPTORcanbus control
unit via a normally open relay (see adjacent diagram).
85
86
30
WHITE
+ 12Vdc
WHITE/GREEN
87
GPS
ECU
RAPTOR
CANBUS
