DAN0749
15
2. SAFETY INSTRUCTIONS
The following symbols are used in these instructions for use:
Denotes risk of personal injury, loss of life or damage to the machine in case of non-observance
of the instructions in this manual.
Indicates electrical shock hazard. Immediately unplug the plug from the mains electricity in the
case that the cord gets damaged and during maintenance
Keep bystanders away
Wear ear and eye protection
SPECIAL SAFETY INSTRUCTIONS
•
Check that the maximum speed indicated on the disc corresponds to the maximum speed of the machine.
The speed of the machine must not exceed the value on the disc.
•
Make sure that the dimensions of the disc correspond to the specifications of the machine.
•
Make sure that the disc has been mounted and fastened properly. Do not use reducing rings or adapters
to make the disc fit properly.
•
Never use this machine single handed. Always use both hands to operate the machine.
•
Do not touch any rotating parts.
•
Make sure the wool bonnet is not contacting the workpiece before the machine is switched on.
•
Do not touch the workpiece immediate after operation. It may be hot
•
Warning:
The wheel still rotates after the machine has been switched off
•
Hold the machine by the insulated grips when performing an operation where contact can be made with
hidden wiring or its own cord.
•
Before use, inspect the disc for any damage. Do not use discs which are cracked, ripped or otherwise
damaged.
•
Before use, let the machine run idle for 30 seconds. Immediately switch off the machine in case of
abnormal vibrations or occurrence of another defect. Carefully inspect the machine and disc before
switching the machine on again.
•
Always wear safety goggles and hearing protection.
•
Ensure that mounted wheels and points are fitted in accordance with the manufacturer’s instructions.
•
For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long
enough to accept the spindle length.
•
Ensure that ventilation openings are kept clear when working in dusty conditions. If it should become
necessary to clear dust, first disconnect the tool from the mains supply (use nonmetallic objects) and
avoid damaging internal parts.
•
Though poor conditions of the electrical mains, shortly voltage drops can appear when starting the
equipment. This can influence other equipment (eq. blinking of a lamp). If the mains-impedance Zmax
Summary of Contents for DAN0749
Page 2: ...DAN0749 2 Fig 2 Fig 3 Fig 1 1 2 3 4 5 6...
Page 3: ...DAN0749 3 1 2 Fig 4 Fig 5 Fig 6 A B...
Page 19: ...DAN0749 19...
