安裝
INSTALLATION
安裝前注意
Notice
安裝程序
Installation Procedure
- 冷氣機周圍不應有任何障礙物阻擋機身，以免影響散熱
There should not be any obstacles surrounding the unit
- 安裝開孔必須稍大於冷氣機機身尺寸
Installation cutout hole must be slightly bigger than the unit size
準備底盤
Prepare chassis
- 鬆開機箱兩邊的鎖扣螺絲
Remove both chassis locking brackets by loosening the screws
- 將底盤取出
Slide the chassis out from the cabinet
利用螺絲將格柵裝於機箱
Affix front grille onto cabinet with a screw
- 將格柵的頂部與機箱頂部扣好，然後按入格柵的底部直至到位，最後用
螺絲鎖好
Hook top of grille onto top of cabinet. Then push and snap bottom of grille into
place. Secure front grille with the screw
!
Horizontal Line
~6-10mm
水平線
Attach Grille
Cabinet
Panel
安放格柵
機箱
面板
提出空氣過濾網
Remove air filter
拆下前面板
Remove front panel
- 去除前面板頂部和底部的黏貼膠帶
Remove the adhesive tape from the top and bottom of the front panel
- 將格柵向上拉出，使頂部兩邊的固定扣從插槽鬆開
Slide the grille upward to free the two tabs at the top of the grille from slots at the top of the cabinet
裝好機箱
Place cabinet into opening
- 安裝時，機箱後方應略為向下傾斜，方便排走冷凝水（約6-10毫米差距）
The cabinet should be installed tilted slightly lower to the rear for
condensation drainage. (Range: 6~10mm)
- 安裝應選擇一個能夠支撐機身重量、同時不會導致額外噪音和震動的位置
Select a location that can support the weight of unit body and one that will
not cause extra noise and vibration during operation
將底盤置入機箱
Slide chassis into the cabinet
- 不應有任何喉管觸碰到機箱
T
ubing or ducting part should not have contact with the cabinet
- 將底盤以兩邊的鎖扣鎖好於機箱
Lock the chassis into cabinet by chassis locking brackets
⑥
①
②
③
④
⑤
P.05
