Operating Instructions
P.7
Time Setting and
- Set time under “Set” mode.
- When the preset time is less than 1 minute, pressing time setting buttons will increase or decrease 5 seconds.
- When the preset time exceeds 1 minute, pressing time setting buttons will increase or decrease 10 seconds.
- Press and hold the time setting buttons to fast forward the time setting.
- The longest time setting is 30:00 (minutes). If it is set to 00:00, the blender has no action.
- To continuously run the food processor, press “ ” to adjust the time setting to “88:88” under
“stand-by” mode. Then, set your desired speed and press the “On / Off ” button. Press the “On / Off ”
button again to stop.
Note: Do not operate continuously for more than 10 min each time.
Speed Setting and
- Set speed under “Set” mode. Speed 1 (the lowest speed) to speed H (the highest speed) can be set by pressing the
speed setting buttons (“ ” & “ ”). The display shows speed 1, 2, 3, 4, 5, 6, 7, 8, 9, H. The speed
can be modified anytime during operation.
Pulse (Momentary Blending)
Under “stand-by” mode, hold down the “Pulse ” button to run in Speed H. It will stop as soon as the
button is released.
Attention
- Check and make sure the electrical rating shown on the rating label corresponds with the power supply in
your house. Insert the plug into the socket, all icons and digits will light up. After 1 second, the unit will turn to
“energy-saving” mode: only “On / Off ” button will light up; the other buttons and the display are off.
- If the food processor is left idle for 3 minutes, it will automatically turn to “energy-saving” mode.
To resume operation, press the “On /
Off ” button first to enter stand-by mode.
- After any program finishes, the blender resumes to stand-by mode.
On/Off Button
- When the power is plugged, the unit will enter “energy-saving mode”. Press this button to enter “stand-by” mode
(all buttons will light up).
- Once time and speed settings are set or a preset program is selected, press this button to start the operation.
Press again to stop.
Set Mode
- Turn iDial to the position where “Set ” lights up, in order to set your preferred time and speed. “Set ” icon
will flash once it is selected.
Set Mode Icon
