German pool MIF-255, User Manual

Page: 4 / 13

P.6 P.7
Operating Instructions Product Structure
Hot milk & beverages
The appliance has got three markings for the filling:
MAX MILK MAX FROTH MIN
maximum milk
level for heating
drinks only
maximum milk
level for making
milk froth
minimum milk level
Note:
- Examine the shipment for its completeness and for any visible damages.
- Immediately notify the carrier and the supplier about any incomplete shipment or damages as a result of
inadequate packaging or due to transportation.
PREPARATION
1. Unpack the Milk Frother, remove all the packaging materials.
2. Clean the appliance thoroughly before the first use. (See chapter Care and maintenance)
3. Setup the appliance in a right location:
• The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing capacity.
• Choose the setup location in such a way that children cannot reach the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable material.
• The electrical socket must be easily accessible so that the power lead can be disconnected easily, in the case of
an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on ships) must be carried out by
specialist companies / electricians, provided they guarantee the prerequisites for the safe use of this device.
4. Electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on the rating plate with those
of your electrical network. This data must agree in order that no damages occur in the device. If in doubt, ask your
qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may employ a 3 meter long (max.) extension cable
with a cross-section of 1.5 mm². The use of multiple plugs or gangs is prohibited because of the danger of fire that
is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the device or over hot or sharp
surfaces.
• The electrical safety of the device is only guaranteed if the device is connected to a properly installed protective
conductor system. Operations using an electrical outlet without a protective conductor are prohibited. If in doubt,
have the house installation checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or damaged protective
conductor.
Warm milk froth Cold milk froth
Lid
Holder with magnetic whisk
Basket for melting (no frother formed)
Jug
Main body
Control panel