German pool HTF-520, User Manual, Page: 5 / 13

P.8 P.9
Installation Method
● Remove the product from the packaging, a total of 2 components: Base 1PCS, remote
control 1PCS
● Put the main unit on a clean desktop, directly press the boot or take out the remote
control to open the carbon fire switch and use it directly.
How to Use Each Function Button
1. After the power is plugged in, the power-on tone is sent to the standby state, the power
indicator light is always on , and all other functions and displays are turned off.
2. In the standby state, pressing the power key to turn on and off.
The status defaults to:
a) Heater Function: ON, LED is on, Low Speed Heater Function is working;
b) Swing: OFF, LED does not light up;
c) Timer: does not light up when timer is not set, LED ; hr is lit when timer is set.
d) Temperature: display the current room temperature, the digital display is lit;
e) Fan: fan is switched on.
f) Temperature setting: automatically set to 25°C;
Note: The temperature regulator function is not executed within 10 seconds after starting up. In the temperature
setting, the keys and can be directly switched to the corresponding warm air or cold air state. The heater
fan must be turned off for 10s.
3. In the power-on state, press the key, the Heater Function power is changed from low-speed to high-speed and
then press again to return to low speed, according to this cycle:
a) Low Speed Heater Function LED lights up,
b) High Speed Heater Function LED lights up, High Speed Heater Function works after 10 seconds delay;
4. In the power-on state, press the key , the fan will change from low-speed to high-speed and then press again
to return to the low-speed, according to this cycle:
a) Low speed: LED lights up;
b) High speed: LED lights up;
Note: When pressing the keys and during heating and cold air switching, the key function is turned off,
and when the keys and are pressed, it is turned off (that is, the Heater Function cannot have cold air
function when operating, and the Heater Function cannot operate when the cold air function is turned on)
5. In the power-on state, press the key to switch the swing function on and off:
a) Swing function On: swing start, LED lights up;
b) Swing function Off: swing stops, LED does not light up;
Note: If it is warm air and the room temperature is higher than the set temperature value, Heater Function will
switch off. After 10 seconds, the fan will turn off and the swing function will not start.
Function Features
1. PTC ceramic heating element can be used to automatically fine-tuned to the change of ambient temperature;
non-oxidation characteristics make it last longer;
2. Two-speed power selection in the cold and warm mode, the hot and cold is adjustable.
3. Hourly timer setting (1hour - 12hour);
4. Automatic wind delivery, gentle winds, uniform heating
5. Room temperature setting function (15°C - 35°C);
6. Adopting a cross-flow cooling fan with low noise (low-level mute function);
7. Tip-over protection feature, double overheat protection device (thermistor, temperature fuse), safer to use;
8. Infrared remote control function, easy to operate;
9. Oscillation function, the wind is supplied at a large angle, the wind is gentle, and the heat is even;
Operating Instructions Operating Instructions
Operation Video
Tutorial
Remote Control Panel
On/Off Swing
Heat Fan
Timer Temp.
On/Off button
Timer up button
Timer down button
Heat button
Swing button
Temperature up button
Temperature down button
Fan button