4
!
Shipping weight and clearance requirements
See the following chart for boxed specifications for the Gerber P2C plotters.
Item Boxed
Size
Weight
Gerber P2C 600
44.5" long x 18.5" wide x 18.5" high
113 cm x 47 cm x 47 cm
52 lbs
24 kg
Gerber P2C 600
optional stand
37" long x 6" wide x 8.5" high
93 cm x 24 cm x 36 cm
35 lbs
16 kg
Gerber P2C 1200
68.5" long x 18.5" wide x 25.5" high
174 cm x 47 cm x 65 cm
114 lbs
62 kg
Gerber P2C 1600
93" long x 28" wide x 22.5" high
236 cm x 71 cm x 57 cm
220.5 lbs
100 kg
You must have enough room to maneuver the packed Gerber P2C plotter to its final location
where you can unpack and assemble it. Corridor and doorway clearance requires a minimum of
30" (76.2 cm). Because of the weight of the Gerber P2C 1600, it must be moved using a pallet jack
or forklift, which may require additional clearance requirements. Alternately, you can assemble
the Gerber P2C 1200 or 1600 and then wheel it to its final location.
When unpacked, the Gerber P2C 1200 or 1600 can be moved easily on its wheels by several
people. Corridor and doorway clearance must be a minimum of 30" (76.2 cm). Please measure
the corridor and doorway clearances. If the clearances are less than 30" (76.2 cm) or you plan on
placing the Gerber P2C 1200 or 1600 plotter on a different floor than where it will be delivered,
you may need a professional rigger to provide assistance with the equipment. Please call
Gerber Service prior to delivery to alert them of any special circumstances
.
!
Receiving and unloading the Gerber P2C plotters
When you complete and return the Site Preparation Checklist (located at the end of this
document), Gerber Service will verify the information.
When the Gerber P2C plotter arrives at your facility, it is your responsibility to take it off the
truck. If you receiving a Gerber P2C 1600 and do not have a loading dock, you will need a
forklift capable of lifting 220 lbs. (100 kg). If you have a loading dock, you can remove the
Gerber P2C boxes from the truck using either a forklift or a pallet jack. If there is no forklift or
loading dock, please request lift gate delivery service when placing your order.
You must have a doorway opening of at least 30" (76.2 cm) to bring the packaged Gerber P2C
plotter into your facility. Do not leave it outside exposed to the elements.
Within several days after the arrival of the Gerber P2C plotter, an installer will install it. The
installer (with your assistance) will unpack the printer, roll it to the operating location, plug it
in, and connect it to your computer. The installer will also demonstrate how to load material
and verify that the Gerber P2C plotter cuts properly.
