5
When the measurement was finished, the
display will show the measured pressure
and pulse value back and forth. Then,
press the power key to turn off the unit.
Otherwise the unit will turn off
automatically in 24 seconds later.
2. Recall the memories
Press and release the MEMORY key to
recall the no. 1 memory. The display will
show the memorized pressure and pulse
value back and forth.
Press and release the MEMORY key
again to recall the no.2 memory. Press
and release repeatedly to read the other
memorized pressures.
3. Clock setting
To enter the setting mode
by pressing and holding the
memory key lasting for over
3 seconds.
The display will show a
blinking year firstly.
Press the power key to adjust
the year when it is blinking.
Secondly, to press and
release the memory key,
the “month” will appear and
blink to be adjusted, and then
“date”, “hour” and “minute” will
follow up as you press and
release the memory key again.
6
To adjust the clock
by pressing the memory key to adjust the
values of the “month”, “date”, “hour”
and “minute” when they are blinking
Care and Maintenance
Do not drop the
unit.
Do not modify or
disassemble the
body or the wrist
cuff.
Do not bend or
twist the wrist
cuff.
Use a moistened
cloth with water or
neutral detergent to
clean the body and
then wipe it dry.
Avoid thinner
and benzine.
Keep the unit in
an suitable place
avoiding high
temperature,
direct sunlight,
high moisture,
and much dust.
Remove the
batteries, if the
unit will be not
used for a long
time.
Do not press the
POWER key when
the cuff has not
been well wrapped.
7
Error Message
Error Marks
Correction
The pressure measured
was lower than 20mmHg.
Please measure again.
The pressure measured
Was higher than
300mmHg.
Please measure again.
The pumping pressure is
higher than 300 mm HG.
Please measure again.
Please replace the
2 batteries.
Check or Replace
the 2 batteries and
try again.
Specification
Name and model Wrist Blood Pressure
Monitor KP-6120,KP-6130
Display system
Liquid Crystal Display
Measuring method Fully fuzzy logic
Power Source
2 Alkaline “AAA” type batteries
(1,5V)
Measuring range
20-300 mmHg
(Cuff Pressure)
40-200 Pulse/minute
(Pulse Rate)
Accuracy
3mmHg
(Cuff Pressure)
5% of Readings
(Pulse Rate)
Inflation
Automatic inflation
(Air Pump)
Deflation
Deflation valve
Rapid air release
Electric release valve
Memory
7 meAverage value
Clock
Year, Month, Date, Time
Error Message
“Err LL” means the pressure
was lower than 20 mmHg.
“ErrUU” means the pressure
was higher than 300 mmHg.
Low battery
Replace the batteries if the
indicator appears.
Power OFF
Automatically after 150
seconds of non use.
8
Battery Life
Approximately 250
measurements.
Operating
+ 10°C to + 40°C
environment
less than 85% RH
Dimensions
78(W) X 74(D)
X 30 mm (H)
Weight
Approx. 130g
(including 2 batteries)
Note : Specification are subject to
change without notice for
improvement.
The blood pressure monitor devices complies
With the European regulations (EU council
directive 93/4
2/EEC) and bears the CE mark “CE
0118”. The quality conforms to the following
standards EN 60601-1-2 (Medical electrical
equipment - Part 1: General requirements for
safety); EN 1060-1 EN 1060-3 ( Non-invasive
sphygmomanometers - Part 1: General
Requirements. Part 3: Supplementary
Requirements to electro-mechanical blood
pressure measuring systems).
Production according to EN ISO 13485.
If used in a professional context, the thermometer
should be inspected every two years by an
authorised laboratory.
Produced for
Geratherm Medical AG
Fahrenheitstraße 1
98716 Geschwenda
Germany
No display
