~65~
3.
Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a)
All lights are off = stand-by mode.
b)
One light is on = the relevant program is running.
c)
One light flashes = Pause - mode.
6.3 Subsequent addition of dishes
You can put dishes later in the appliance unless the detergent container has opened.
1.
Open the door slightly to stop operation.
2.
You can open the door completely after the rotating spray arms stopped
operation.
3.
Now you can add dishes.
4.
When you close the door, the appliance starts operating after 10 seconds.
6.4 End of a program
When the display indicates "-" and the acoustic signal sounds 6 times, the program
has ended.
1.
Switch off the appliance (ON/OFF button).
2.
Turn off the water.
3.
CAUTION!
Wait a few minutes before you open the door as hot
damp may escape.
4.
Wait approx. 15 minutes before you take out the dishes. The dishes are still hot
and will break easily.
5.
It is normal that the appliance is wet inside.
7. Cleaning and maintenance
1.
WARNING!
Disconnect the appliance from the mains before you
clean or maintain it.
2.
Always keep the appliance clean so that unpleasant odours do not occur.
3.
Take off all rings and bracelets before cleaning or maintaining the appliance;
otherwise you will damage the surface of the appliance.