5
2.2
Fixed Bullet IP Camera Installation
Step 1:
Connect the cables to the corresponding interface on the rear cover of the Junction
Box. Then fix the rear cover on the position where it is intended to be installed. The rear cover
can be fixed in the following two ways:
1. Fix the rear cover directly
2. Fix the rear cover via a bracket
Note:
The bracket is optional, which can be applied in special scenarios that require screws
of larger sizes.
Step 2:
When the front cover is correctly fixed to the rear cover, the camera will be powered
on by contact power supply. Adjust shooting direction and rotate locking ring.
Note:
Loosen the screws of SD card structure to get access to the SD card slot if you need.
Fix the screws again after inserting the SD card to complete the operation.
