Installing Camera Module
Push the sun shield forward to align with
the back of camera enclosure.
1.
Slightly lift the camera module and slide it
out completely.
4.
Remove the foam.
5.
2.
Pull out the camera module.
Sun Shield
Camera Enclosure Back
Camera Module
Completely slide the camera
module out
Loosen the set screws on the back of the
camera enclosure.
3.
Loosen the screw cap on the right.
6.
Insert the video cable through the screw
cap and the inside rubber of the cap.
7.
Rubber
Screw Cap
Attach the video cable to the BNC
connector and plug it into the “VIDEO OUT”
jack.
8.
Adjust the length of the video cable and
seal it with the waterproof tape.
9.
Tightly screw the cap.
10.
Loosen the screw cap on the left, insert the
power cable through the screw cap and the
inside rubber.
11.
Remove the terminal block. Plug black and
white wires of the power cable to the
terminal block. Reinsert the terminal block
onto the camera. The white wire is required
to connect to the positive pin (+) on the
camera and the black wire to the negative
pin (-).
12.
VIDEO OUT
Jack
Adjust the length of the cable, seal it with
the waterproof tape, and then tightly screw
the cap (see Steps 9 and 10 for the
pictures).
13.
