Geotech SP 31509, Assembly & Operating Instructions

Page: 16 / 19

16
Step 8
OPERATION
How to use your spiker/spreader?
11. Determine the approximate square footage of the area to be covered and estimate the
amount of fertilizer or seed required.
12. Move the spreader to the area where application is to begin.
13. Loosen the plastic wing nut and move it to the desired setting. Retighten the nut.
14.
Making sure the flow control lever is in the “OFF” position, fill the hopper, breaking up any
lumps.
15. Lower the aerator spikes to the operating position.
16.
Start the spreader in motion and then move the flow control lever to the “ON” position as you
travel across your lawn. The recommended towing speed is 3 m.p.h.
17. Do not make sharp turns with spikes in the ground
18. Raise aerator spikes to transport position when crossing over concrete or other hard
surfaces.
19. Do not aerate if the ground is extremely hard or dry. If ground is too dry, sprinkle or water for
one to two hours prior to use.
20. Do not aerate if the ground is too wet (muddy)