SVC-821 ASSEMBLY INSTRUCTION
REV:EN301013-03
Copyright 2006-2015 © Geoscanners AB
6
5.
Connect the control cable between the
Akula9000 unit and the antenna in use.
6.
After connecting the control cable you are
ready to install the battery in the rear top part
of the antenna, where the plastic hinges of the
frame are located.
Insert the black belt under the hinges on both
sides. Secure the battery in place with the aid
of the plastics locks . Connect the battery cable
to the power input on your control unit Akula
9000.
The only thing left to do is to connect the
supplied USB cable to the radar and then to
the user control computer. Now your ground
penetrating radar survey system is ready to
work.
IMPORTANT
Always make sure to connect and disconnect
the control cable while the battery is
disconnected, or while the Akula 9000 unit is
OFF.
If you connect the control cable with the
antenna connected to a control unit that is
powered up, there is a risk of damage to
your control unit, the antenna or both. It is
worth mentioning that this kind of failure is
not covered by the warranty. So, please make
absolutely sure the radar is OFF before you
proceed to connect the control cable to it.
