ELECTRICAL CONNECTIONS
4
WARNING
WARNING! Read these electrical safety instructions thoroughly before connecting the
product to the mains supply.
Before switching the product on, make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate. Connecting it to any other power source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to change the fuse in the plug,
the fuse cover must be refitted. If the fuse cover becomes lost or damaged, the plug must not be used
until a suitable replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or due to damage, it should
be cut off and a replacement fitted, following the wiring instructions shown below. The old plug must
be disposed of safely, as insertion into a mains socket could cause an electrical hazard.
ASSEMBLY
1. With spring loaded lid closed, place Tub unit
upside down on a non-scratching surface
(cardboard, carpet etc.).
2. Attach each of the 4 legs with 4 sets each of 6mm
screws, lockwashers and nuts to the brackets on the
Tub unit (Fig 1).
3. Attach Storage Tray to holes located mid-way of 4
legs with 2 sets each of 6mm screws, lockwashers
and nuts (Fig 2).
4. Return the Tub unit to the upright position on its
legs and open the springtensioned lid.
5. Thread the fitting of the Flexible Metal
“Gooseneck” fluid outlet tube onto the Pump outlet
(Fig 3). Place the Pump Box Lid over the open Pump
Box with fluid intake perforations and raised ribs
downward and over pump. Snap into place (Fig 3).
